Datasheet

 1999-2013 Microchip Technology Inc. DS41106C-page 77
PIC16C712/716
12.3 DC Characteristics: PIC16C712/716-04 (Commercial, Industrial, Extended)
PIC16C712716-20 (Commercial, Industrial, Extended)
PIC16LC712/716-04 (Commercial, Industrial)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature 0°C  T
A  +70°C for commercial
-40°C  T
A  +85°C for industrial
-40°C  T
A  +125°C for extended
Operating voltage V
DD range as described in DC spec Section 12.1
“DC Characteristics: PIC16C712/716-04 (Commercial, Industrial,
Extended) PIC16C712/716-20 (Commercial, Industrial,
Extended)” and Section 12.2 “DC Characteristics: PIC16LC712/
716-04 (Commercial, Industrial)”
Param
No.
Sym. Characteristic Min. Typ† Max. Units Conditions
Input Low Voltage
V
IL I/O ports
D030
D030A
with TTL buffer V
SS
VSS
—
—
0.8V
0.15V
DD
V
V
4.5V  VDD  5.5V
otherwise
D031 with Schmitt Trigger buffer V
SS — 0.2VDD V
D032 MCLR
, OSC1 (in RC mode) Vss — 0.2VDD V
D033 OSC1 (in XT, HS and LP
modes)
Vss
— 0.3VDD V (Note 1)
Input High Voltage
V
IH I/O ports —
D040 with TTL buffer 2.0 — VDD V 4.5V  VDD  5.5V
D040A 0.25V
DD
+ 0.8V
— VDD Votherwise
D041 with Schmitt Trigger buffer 0.8V
DD — VDD V For entire VDD range
D042 MCLR
0.8VDD — VDD V
D042A OSC1 (XT, HS and LP modes) 0.7V
DD — VDD V (Note 1)
D043 OSC1 (in RC mode) 0.9V
DD — VDD V
Input Leakage Current
(Notes 2, 3)
D060 I
IL I/O ports ——1 AVss VPIN VDD,
Pin at high-impedance
D061 MCLR, RA4/T0CKI ——5 AVss VPIN VDD
D063 OSC1 ——5 AVss VPIN VDD,
XT, HS and LP osc modes
D070 I
PURB PORTB weak pull-up current 50 250 400 A VDD = 5V, VPIN = VSS
* These parameters are characterized but not tested.
† Data in “Typ” column is at 5V, 25C unless otherwise stated. These parameters are for design guidance only
and are not tested.
Note 1: In RC Oscillator mode, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that the PIC
MCU be driven with external clock in RC mode.
2: The leakage current on the MCLR
/VPP pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.