Datasheet

 1997 Microchip Technology Inc. DS30272A-page 93
PIC16C71X
Applicable Devices 710 71 711 715
Output Low Voltage
D080 I/O ports V
OL - - 0.6 V IOL = 8.5 mA, VDD = 4.5V,
-40°C to +85°C
D080A - - 0.6 V I
OL = 7.0 mA, VDD = 4.5V,
-40°C to +125°C
D083 OSC2/CLKOUT (RC osc config) - - 0.6 V I
OL = 1.6 mA, VDD = 4.5V,
-40°C to +85°C
D083A - - 0.6 V I
OL = 1.2 mA, VDD = 4.5V,
-40°C to +125°C
Output High Voltage
D090 I/O ports (Note 3) V
OH VDD - 0.7 - - V IOH = -3.0 mA, VDD = 4.5V,
-40°C to +85°C
D090A V
DD - 0.7 - - V IOH = -2.5 mA, VDD = 4.5V,
-40°C to +125°C
D092 OSC2/CLKOUT (RC osc config) V
DD - 0.7 - - V IOH = -1.3 mA, VDD = 4.5V,
-40°C to +85°C
D092A V
DD - 0.7 - - V IOH = -1.0 mA, VDD = 4.5V,
-40°C to +125°C
D130* Open-Drain High Voltage V
OD - - 14 V RA4 pin
Capacitive Loading Specs on
Output Pins
D100 OSC2 pin C
OSC2 - - 15 pF In XT, HS and LP modes when
external clock is used to drive
OSC1.
D101 All I/O pins and OSC2 (in RC mode) C
IO - - 50 pF
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature 0˚C ≤ T
A ≤ +70˚C (commercial)
-40˚C ≤ T
A ≤ +85˚C (industrial)
-40˚C ≤ T
A ≤ +125˚C (extended)
Operating voltage V
DD range as described in DC spec Section 11.1 and
Section 11.2.
Param
No.
Characteristic Sym Min Typ
†
Max Units Conditions
* These parameters are characterized but not tested.
† Data in “Typ” column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance only
and are not tested.
Note 1: In RC oscillator configuration, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that the
PIC16C7X be driven with external clock in RC mode.
2: The leakage current on the MCLR
pin is strongly dependent on the applied voltage level. The specified levels
represent normal operating conditions. Higher leakage current may be measured at different input voltages.
3: Negative current is defined as current sourced by the pin.