Datasheet
1997 Microchip Technology Inc. DS30272A-page 139
PIC16C71X
Applicable Devices 710 71 711 715
Capacitive Loading Specs on
Output Pins
D100 OSC2 pin C
OSC2 15 pF In XT, HS and LP modes when
external clock is used to drive
OSC1.
D101 All I/O pins and OSC2 (in RC mode) C
IO 50 pF
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
OOperating temperature 0˚C ≤ T
A ≤ +70˚C (commercial)
-40˚C ≤ T
A ≤ +85˚C (industrial)
Operating voltage V
DD range as described in DC spec Section 15.1
and Section 15.2.
Param
No.
Characteristic Sym Min Typ
†
Max Units Conditions
† Data in “Typ” column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance only
and are not tested.
Note 1: In RC oscillator configuration, the OSC1 pin is a Schmitt trigger input. It is not recommended that the
PIC16C71 be driven with external clock in RC mode.
2: The leakage current on the MCLR
pin is strongly dependent on the applied voltage level. The specified levels
represent normal operating conditions. Higher leakage current may be measured at different input voltages.
3: Negative current is defined as current sourced by the pin.
4: PIC16C71 Rev. "Ax" INT pin has a TTL input buffer. PIC16C71 Rev. "Bx" INT pin has a Schmitt Trigger input
buffer.