Datasheet

PIC16C71X
DS30272A-page 118  1997 Microchip Technology Inc.
Applicable Devices 710 71 711 715
13.5 Timing Diagrams and Specifications
FIGURE 13-2: EXTERNAL CLOCK TIMING
TABLE 13-2: CLOCK TIMING REQUIREMENTS
Parameter
No.
Sym Characteristic Min Typ† Max Units Conditions
Fos External CLKIN Frequency
(Note 1)
DC — 4 MHz XT osc mode
DC — 4 MHz HS osc mode (PIC16C715-04)
DC — 20 MHz HS osc mode (PIC16C715-20)
DC — 200 kHz LP osc mode
Oscillator Frequency
(Note 1)
DC — 4 MHz RC osc mode
0.1 — 4 MHz XT osc mode
4 — 4 MHz HS osc mode (PIC16C715-04)
4
4
5
—
—
—
10
20
200
MHz
MHz
kHz
HS osc mode (PIC16C715-10)
HS osc mode (PIC16C715-20)
LP osc mode
1 Tosc External CLKIN Period
(Note 1)
250 — — ns XT osc mode
250 — — ns HS osc mode (PIC16C715-04)
100 — — ns HS osc mode (PIC16C715-10)
50 — — ns HS osc mode (PIC16C715-20)
5 — — µs LP osc mode
Oscillator Period
(Note 1)
250 — — ns RC osc mode
250 — 10,000 ns XT osc mode
250 — 250 ns HS osc mode (PIC16C715-04)
100
50
—
—
250
250
ns
ns
HS osc mode (PIC16C715-10)
HS osc mode (PIC16C715-20)
5 — — µs LP osc mode
2 T
CY Instruction Cycle Time (Note 1) 200 — DC ns TCY = 4/FOSC
3 TosL,
TosH
External Clock in (OSC1) High
or Low Time
50 — — ns XT oscillator
2.5 — — µs LP oscillator
10 — — ns HS oscillator
4 TosR,
TosF
External Clock in (OSC1) Rise
or Fall Time
— — 25 ns XT oscillator
— — 50 ns LP oscillator
— — 15 ns HS oscillator
† Data in "Typ" column is at 5V, 25˚C unless otherwise stated. These parameters are for design guidance only and are not
tested.
Note 1: Instruction cycle period (T
CY) equals four times the input oscillator time-base period. All specified values are based on
characterization data for that particular oscillator type under standard operating conditions with the device executing code.
Exceeding these specified limits may result in an unstable oscillator operation and/or higher than expected current con-
sumption. All devices are tested to operate at "min." values with an external clock applied to the OSC1/CLKIN pin.
When an external clock input is used, the "Max." cycle time limit is "DC" (no clock) for all devices. OSC2 is disconnected
(has no loading) for the PIC16C715.
OSC1
CLKOUT
Q4 Q1 Q2 Q3 Q4 Q1
1
2
3
3
4
4