Datasheet

PIC16C71X
DS30272A-page 116  1997 Microchip Technology Inc.
Applicable Devices 710 71 711 715
Output High Voltage
D090 I/O ports (Note 3) V
OH VDD - 0.7 - - V IOH = -3.0 mA, VDD = 4.5V,
-40°C to +85°C
D090A V
DD - 0.7 - - V IOH = -2.5 mA, VDD = 4.5V,
-40°C to +125°C
D092 OSC2/CLKOUT (RC osc config) V
DD - 0.7 - - V IOH = -1.3 mA, VDD = 4.5V,
-40°C to +85°C
D092A V
DD - 0.7 - - V IOH = -1.0 mA, VDD = 4.5V,
-40°C to +125°C
Capacitive Loading Specs on
Output Pins
D100 OSC2 pin C
OSC2 - - 15 pF In XT, HS and LP modes when
external clock is used to drive
OSC1.
D101 All I/O pins and OSC2 (in RC mode) C
IO - - 50 pF
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature 0˚C ≤ T
A ≤ +70˚C (commercial)
-40˚C ≤ T
A ≤ +85˚C (industrial)
-40˚C ≤ T
A ≤ +125˚C (extended)
Operating voltage V
DD range as described in DC spec Section 13.1
and Section 13.2.
Param
No.
Characteristic Sym Min Typ
†
Max Units Conditions
† Data in “Typ” column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance only
and are not tested.
Note 1: In RC oscillator configuration, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that the
PIC16C7X be driven with external clock in RC mode.
2: The leakage current on the MCLR
pin is strongly dependent on the applied voltage level. The specified levels
represent normal operating conditions. Higher leakage current may be measured at different input voltages.
3: Negative current is defined as coming out of the pin.