Datasheet

PIC16C6X
DS30234E-page 166  1997-2013 Microchip Technology Inc.
Applicable Devices 61 62 62A R62 63 R63 64 64A R64 65 65A R65 66 67
FIGURE 15-3: CLKOUT AND I/O TIMING
TABLE 15-3: CLKOUT AND I/O TIMING REQUIREMENTS
Parameter
No.
Sym Characteristic Min Typ† Max Units Conditions
10* TosH2ckL OSC1 to CLKOUT —1530nsNote 1
11* TosH2ckH OSC1 to CLKOUT —1530nsNote 1
12* TckR CLKOUT rise time — 5 15 ns Note 1
13* TckF CLKOUT fall time — 5 15 ns Note 1
14* TckL2ioV CLKOUT  to Port out valid — — 0.5T
CY + 20 ns Note 1
15* TioV2ckH Port in valid before CLKOUT  0.25T
CY + 25 — — ns Note 1
16* TckH2ioI Port in hold after CLKOUT  0——nsNote 1
17* TosH2ioV OSC1 (Q1 cycle) to Port out valid — — 80 - 100 ns
18* TosH2ioI OSC1 (Q2 cycle) to Port input invalid
(I/O in hold time)
TBD — — ns
19* TioV2osH Port input valid to OSC1(I/O in setup
time)
TBD — — ns
20* TioR Port output rise time PIC16C61 — 10 25 ns
PIC16LC61 — — 60 ns
21* TioF Port output fall time PIC16C61 — 10 25 ns
PIC16LC61 — — 60 ns
22††* Tinp RB0/INT pin high or low time 20 — — ns
23††* Trbp RB7:RB4 change int high or low time 20 — — ns
* These parameters are characterized but not tested.
† Data in "Typ" column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance only and are not
tested.
†† These parameters are asynchronous events not related to any internal clock edges.
Note 1: Measurements are taken in RC Mode where CLKOUT output is 4 x T
OSC.
OSC1
CLKOUT
I/O Pin
(input)
I/O Pin
(output)
Q4
Q1
Q2 Q3
10
13
14
17
20, 21
19
18
15
11
12
16
old value
new value
Note: Refer to Figure 15-1 for load conditions.