Datasheet
1997-2013 Microchip Technology Inc. Preliminary DS30453E-page189
PIC16C5X
PRODUCT IDENTIFICATION SYSTEM
To order or obtain information, e.g., on pricing or delivery, refer to the factory or the listed sales office.
Sales and Support
PART NO. X /XX XXX
PatternPackageTemperature
Range
Device
Device PIC16C54 PIC16C54T
(2)
PIC16C54A PIC16C54AT
(2)
PIC16CR54A PIC16CR54AT
(2)
PIC16C54C PIC16C54CT
(2)
PIC16CR54C PIC16CR54CT
(2)
PIC16C55 PIC16C55T
(2)
PIC16C55A PIC16C55AT
(2)
PIC16C56 PIC16C56T
(2)
PIC16C56A PIC16C56AT
(2)
PIC16CR56A PIC16CR56AT
(2)
PIC16C57 PIC16C57T
(2)
PIC16C57C PIC16C57CT
(2)
PIC16CR57C PIC16CR57CT
(2)
PIC16C58B PIC16C58BT
(2)
PIC16CR58B PIC16CR58BT
(2)
Frequency Range/
Oscillator Type
RC Resistor Capacitor
LP Low Power Crystal
XT Standard Crystal/Resonator
HS High Speed Crystal
02 200 KHz (LP) or 2 MHz (XT and RC)
04 200 KHz (LP) or 4 MHz (XT and RC)
10 10 MHz (HS only)
20 20 MHz (HS only)
40 40 MHz (HS only)
b
(4)
No oscillator type for JW packages
(3)
*RC/LP/XT/HS are for 16C54/55/56/57 devices only
-02 is available for 16LV54A only
-04/10/20 options are available for all other devices
-40 is available for 16C54C/55A/56A/57C/58B devices only
Temperature Range b
(4)
=0C to +70C
I=-40C to +85C
E=-40C to +125C
Package S = Die in Waffle Pack
JW = 28-pin 600 mil/18-pin 300 mil windowed CER-
DIP
(3)
P = 28-pin 600 mil/18-pin 300 mil PDIP
SO = 300 mil SOIC
SS = 209 mil SSOP
SP = 28-pin 300 mil Skinny PDIP
*See Section 21 for additional package information.
Pattern QTP, SQTP, ROM code (factory specified) or Special
Requirements. Blank for OTP and Windowed devices.
Examples:
a) PIC16C55A - 04/P 301 = Commercial Temp.,
PDIP package, 4 MHz, standard V
DD limits,
QTP pattern #301
b) PIC16LC54C - 04I/SO Industrial Temp., SOIC
package, 200 kHz, extended V
DD limits
c) PIC16C57 - RC/SP = RC Oscillator, commer-
cial temp, skinny PDIP package, 4 MHz, stan-
dard V
DD limits
d) PIC16C58BT -40/SS 123 = commercial
temp, SSOP package in tape and reel, 4
MHz, extended V
DD limits, ROM pattern
#123
Note 1: C = normal voltage range
LC = extended
2: T = in tape and reel - SOIC and SSOP
packages only
3: JW Devices are UV erasable and can be
programmed to any device configura-
tion. JW Devices meet the electrical
requirements of each oscillator type,
including LC devices.
4: b = Blank
XX
Frequency
Range/OSC
Type
-
Data Sheets
Products supported by a preliminary Data Sheet may have an errata sheet describing minor operational differences and recom-
mended workarounds. To determine if an errata sheet exists for a particular device, please contact one of the following:
1. Your local Microchip sales office
2. The Microchip Worldwide Site (www.microchip.com)