Datasheet
1999-2012 Microchip Technology Inc. DS40192D-page 61
PIC16C505
Output High Voltage
D090 I/O ports/CLKOUT (Note 3) V
OH VDD - 0.7
——
VIOH = -3.0 mA, VDD = 4.5V,
–40C to +85C
D090A VDD - 0.7
——
VIOH = -2.5 mA, VDD = 4.5V,
–40C to +125C
D092 OSC2 VDD - 0.7
——
VIOH = -1.3 mA, VDD = 4.5V,
–40C to +85C
D092A V
DD - 0.7
——
VIOH = -1.0 mA, VDD = 4.5V,
–40C to +125C
Capacitive Loading Specs on
Output Pins
D100 OSC2 pin COSC2
——
15 pF In XT, HS and LP modes when
external clock is used to drive
OSC1.
D101 All I/O pins and OSC2 C
IO
——
50 pF
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise specified)
Operating temperature 0°C T
A +70°C (commercial)
–40°C T
A +85°C (industrial)
–40°C T
A +125°C (extended)
Operating voltage V
DD range as described in DC spec Section 10.1 and
Section 10.3.
Param
No.
Characteristic Sym Min Typ† Max Units Conditions
† Data in “Typ” column is at 5V, 25C unless otherwise stated. These parameters are for design guidance only and are not
tested.
Note 1: In EXTRC oscillator configuration, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that the PIC16C505
be driven with external clock in RC mode.
2: The leakage current on the MCLR
pin is strongly dependent on the applied voltage level. The specified levels represent nor-
mal operating conditions. Higher leakage current may be measured at different input voltages.
3: Negative current is defined as coming out of the pin.
4: Does not include GP3. For GP3 see parameters D061 and D061A.
5: This spec. applies to GP3/MCLR
configured as external MCLR and GP3/MCLR configured as input with internal pull-up
enabled.
6: This spec. applies when GP3/MCLR
is configured as an input with pull-up disabled. The leakage current of the MCLR circuit
is higher than the standard I/O logic.