Datasheet

PIC12F683
DS41211D-page 30 © 2007 Microchip Technology Inc.
FIGURE 3-9: FSCM TIMING DIAGRAM
TABLE 3-2: SUMMARY OF REGISTERS ASSOCIATED WITH CLOCK SOURCES
Name Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Value on
POR, BOR
Value on
all other
Resets
(1)
CONFIG
(2)
CPD CP MCLRE
PWRTE
WDTE FOSC2 FOSC1 FOSC0 — —
INTCON GIE PEIE
T0IE INTE GPIE T0IF INTF GPIF 0000 0000 0000 000x
OSCCON
— IRCF2 IRCF1 IRCF0 OSTS HTS LTS SCS -110 x000 -110 x000
OSCTUNE
— — — TUN4 TUN3 TUN2 TUN1 TUN0 ---0 0000 ---u uuuu
PIE1
EEIE ADIE CCP1IE — CMIE OSFIE TMR2IE TMR1IE 000- 0000 000- 0000
PIR1
EEIF ADIF CCP1IF — CMIF OSFIF TMR2IF TMR1IF 000- 0000 000- 0000
Legend: x = unknown, u = unchanged, – = unimplemented locations read as ‘0’. Shaded cells are not used by oscillators.
Note 1: Other (non Power-up) Resets include MCLR
Reset and Watchdog Timer Reset during normal operation.
2: See Configuration Word register (Register 12-1) for operation of all register bits.
OSCFIF
System
Clock
Output
Sample Clock
Failure
Detected
Oscillator
Failure
Note: The system clock is normally at a much higher frequency than the sample clock. The relative frequencies in
this example have been chosen for clarity.
(Q)
Test
Test Test
Clock Monitor Output