Datasheet

PIC12F609/615/617/12HV609/615
DS41302D-page 68  2010 Microchip Technology Inc.
9.2 Analog Input Connection
Considerations
A simplified circuit for an analog input is shown in
Figure 9-3. Since the analog input pins share their
connection with a digital input, they have reverse
biased ESD protection diodes to V
DD and VSS. The
analog input, therefore, must be between V
SS and VDD.
If the input voltage deviates from this range by more
than 0.6V in either direction, one of the diodes is
forward biased and a latch-up may occur.
A maximum source impedance of 10 k is
recommended for the analog sources. Also, any
external component connected to an analog input pin,
such as a capacitor or a Zener diode, should have very
little leakage current to minimize inaccuracies
introduced.
FIGURE 9-3: ANALOG INPUT MODEL
Note 1: When reading a GPIO register, all pins
configured as analog inputs will read as a
‘0’. Pins configured as digital inputs will
convert as an analog input, according to
the input specification.
2: Analog levels on any pin defined as a
digital input, may cause the input buffer to
consume more current than is specified.
VA
RS < 10K
C
PIN
5 pF
VDD
VT  0.6V
VT  0.6V
RIC
ILEAKAGE
±500 nA
V
SS
AIN
Legend: CPIN = Input Capacitance
I
LEAKAGE = Leakage Current at the pin due to various junctions
R
IC = Interconnect Resistance
R
S = Source Impedance
V
A = Analog Voltage
V
T = Threshold Voltage
To Comparator