Datasheet

 2010 Microchip Technology Inc. DS41302D-page 153
PIC12F609/615/617/12HV609/615
D101* COSC2
Capacitive Loading Specs on
Output Pins
OSC2 pin
— — 15 pF In XT, HS and LP modes when
external clock is used to drive
OSC1
D101A* C
IO All I/O pins — — 50 pF
Program Flash Memory
D130 E
P Cell Endurance 10K 100K — E/W -40°C  TA +85°C
D130A E
D Cell Endurance 1K 10K — E/W +85°C  TA +125°C
D131 V
PR VDD for Read VMIN —5.5VVMIN = Minimum operating
voltage
D132 V
PEW VDD for Bulk Erase/Write 4.5 — 5.5 V
D132A V
PEW VDD for Row Erase/Write
(6)
VMIN —5.5V
D133 T
PEW Erase/Write cycle time — 2 2.5 ms
D134 T
RETD Characteristic Retention 40 — — Year Provided no other specifications
are violated
16.8 DC Characteristics: PIC12F609/615/617/12HV609/615-I (Industrial)
PIC12F609/615/617/12HV609/615-E (Extended) (Continued)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for industrial
-40°C  T
A  +125°C for extended
Param
No.
Sym Characteristic Min Typ† Max Units Conditions
* These parameters are characterized but not tested.
† Data in “Typ” column is at 5.0V, 25°C unless otherwise stated. These parameters are for design guidance only and are
not tested.
Note 1: In RC oscillator configuration, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended to use an external
clock in RC mode.
2: Negative current is defined as current sourced by the pin.
3: The leakage current on the MCLR
pin is strongly dependent on the applied voltage level. The specified levels represent
normal operating conditions. Higher leakage current may be measured at different input voltages.
4: This specification applies to GP3/MCLR
configured as GP3 with the internal weak pull-up disabled.
5: This specification applies to all weak pull-up pins, including the weak pull-up found on GP3/MCLR
. When GP3/MCLR is
configured as MCLR
reset pin, the weak pull-up is always enabled.
6: Applies to PIC12F617 only.