Datasheet

PIC12F609/615/617/12HV609/615
DS41302D-page 150  2010 Microchip Technology Inc.
16.6 DC Characteristics: PIC12HV609/615 - I (Industrial)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  T
A  +85°C for industrial
Param
No.
Device Characteristics Min Typ† Max Units
Conditions
V
DD Note
D020 Power-down Base
Current (IPD)
(2,3)
—135200A 2.0 WDT, BOR, Comparator, V
REF and
T1OSC disabled
—210280A3.0
PIC12HV609/615 — 260 350 A4.5
D021 — 135 200 A 2.0 WDT Current
(1)
—210285A3.0
—265360A4.5
D022 — 215 285 A 3.0 BOR Current
(1)
—265360A4.5
D023 — 185 270 A 2.0 Comparator Current
(1)
, single
comparator enabled
—265350A3.0
—320430A4.5
D024 — 165 235 A2.0CV
REF Current
(1)
(high range)
—255330A3.0
—330430A4.5
D025* — 175 245 A2.0CV
REF Current
(1)
(low range)
—275350A3.0
—355450A4.5
D026 — 140 205 A 2.0 T1OSC Current
(1)
, 32.768 kHz
—220290A3.0
—270360A4.5
D027 — 210 280 A 3.0 A/D Current
(1)
, no conversion in
progress
—260350A4.5
* These parameters are characterized but not tested.
† Data in “Typ” column is at 4.5V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: The peripheral current is the sum of the base I
DD or IPD and the additional current consumed when this
peripheral is enabled. The peripheral  current can be determined by subtracting the base I
DD or IPD
current from this limit. Max values should be used when calculating total current consumption.
2: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is
measured with the part in Sleep mode, with all I/O pins in high-impedance state and tied to V
DD.
3: Shunt regulator is always on and always draws operating current.