Datasheet

 2010 Microchip Technology Inc. DS41302D-page 147
PIC12F609/615/617/12HV609/615
16.3 DC Characteristics: PIC12HV609/615-I (Industrial)
PIC12HV609/615-E (Extended)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for industrial
-40°C  T
A  +125°C for extended
Param
No.
Device Characteristics Min Typ† Max Units
Conditions
V
DD Note
D010 Supply Current (I
DD)
(1, 2)
—
160 230
A2.0FOSC = 32 kHz
LP Oscillator mode
PIC12HV609/615 — 240 310 A3.0
— 280 400 A4.5
D011*
— 270 380 A2.0FOSC = 1 MHz
XT Oscillator mode
— 400 560 A3.0
— 520 780 A4.5
D012 — 380 540 A2.0F
OSC = 4 MHz
XT Oscillator mode
— 575 810 A3.0
— 0.875 1.3 mA 4.5
D013* — 215 310 A2.0F
OSC = 1 MHz
EC Oscillator mode
— 375 565 A3.0
— 570 870 A4.5
D014 — 330 475 A2.0F
OSC = 4 MHz
EC Oscillator mode
— 550 800 A3.0
— 0.85 1.2 mA 4.5
D016* — 310 435 A2.0F
OSC = 4 MHz
INTOSC mode
— 500 700 A3.0
— 0.74 1.1 mA 4.5
D017 — 460 650 A2.0F
OSC = 8 MHz
INTOSC mode
— 0.75 1.1 mA 3.0
— 1.2 1.6 mA 4.5
D018 — 320 465 A2.0F
OSC = 4 MHz
EXTRC mode
(3)
— 510 750 A3.0
— 0.770 1.0 mA 4.5
D019 — 2.5 3.4 mA 4.5 F
OSC = 20 MHz
HS Oscillator mode
* These parameters are characterized but not tested.
† Data in “Typ” column is at 4.5V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: The test conditions for all I
DD measurements in active operation mode are: OSC1 = external square wave,
from rail-to-rail; all I/O pins tri-stated, pulled to V
DD; MCLR = VDD; WDT disabled.
2: The supply current is mainly a function of the operating voltage and frequency. Other factors, such as I/O
pin loading and switching rate, oscillator type, internal code execution pattern and temperature, also have
an impact on the current consumption.
3: For RC oscillator configurations, current through R
EXT is not included. The current through the resistor can
be extended by the formula I
R = VDD/2REXT (mA) with REXT in k