Datasheet

 2013-2015 Microchip Technology Inc. DS40001723D-page 265
PIC12(L)F1571/2
D018A* — 2 2.4 mA 3.0 FOSC = 32 MHz,
HFINTOSC (Note 3)
D018A* — 2.1 2.5 mA 3.0 FOSC = 32 MHz,
HFINTOSC (Note 3)
— 2.2 2.6 mA 5.0
D019A — 1.7 1.9 mA 3.0 F
OSC = 32 MHz,
External Clock (ECH),
High-Power mode (Note 3)
D019A — 1.8 2 mA 3.0 FOSC = 32 MHz,
External Clock (ECH),
High-Power mode (Note 3)
— 1.9 2.3 mA 5.0
D019B — 2.2 5.9 A1.8FOSC = 32 kHz,
External Clock (ECL),
Low-Power mode
—4.38.3A3.0
D019B — 12 20 A 2.3 FOSC = 32 kHz,
External Clock (ECL),
Low-Power mode
— 15 25 A 3.0
— 17 26 A 5.0
D019C — 18 25 A1.8F
OSC = 500 kHz,
External Clock (ECL),
Low-Power mode
—3038A3.0
D019C — 29 40 A 2.3 FOSC = 500 kHz,
External Clock (ECL),
Low-Power mode
— 37 51 A 3.0
— 42 53 A 5.0
TABLE 26-2: SUPPLY CURRENT (IDD)
(1,2)
(CONTINUED)
PIC12LF1571/2 Standard Operating Conditions (unless otherwise stated)
PIC12F1571/2
Param.
No.
Device
Characteristics
Min. Typ† Max. Units
Conditions
V
DD Note
* These parameters are characterized but not tested.
† Data in “Typ” column is at 3.0V, +25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: The test conditions for all IDD measurements in active operation mode are: CLKIN = external square wave,
from rail-to-rail; all I/O pins tri-stated, pulled to V
SS; MCLR = VDD; WDT disabled.
2: The supply current is mainly a function of the operating voltage and frequency. Other factors, such as I/O
pin loading and switching rate, oscillator type, internal code execution pattern and temperature, also have
an impact on the current consumption.
3: PLL required for 32 MHz operation.