Information

PIC10(L)F320/322
DS80000529E-page 8  2011-2013 Microchip Technology Inc.
4. Module: Numerically Controlled
Oscillator (NCO) Module
Register 20-2, NCOxCLK, NxCKS bits (bits 1:0)
should read:
REGISTER 20-2: NCOxCLK: NCOx INPUT CLOCK CONTROL REGISTER
5. Module: In-Circuit Serial Programming
TM
(ICSP
TM
)
In the second paragraph of section 22.0 In-Circuit
Serial Programming
TM
(ICSP
TM
), the
programming specification being referenced
should be PIC10(L)F320/322 Flash Memory
Programming Specification (DS41572):
“In Program/Verify mode, the Program Memory,
User IDs and the Configuration Words are
programmed through serial communications. The
ICSPDAT pin is a bidirectional I/O used for
transferring the serial data and the ICSPCLK pin is
the clock input. For more information on ICSP™
refer to the “PIC10(L)F320/322 Flash Memory
Programming Specification” (DS41572)”.
6. Module: In-Circuit Serial Programming
TM
(ICSP
TM
)
Table 27-2: 6-LEAD SOT23 (OT) PACKAGE TOP
MARKING should include additional package
marking codes for the PIC10F322(T)-I/OT and the
PIC10F322(T)-E/OT devices. See the corrected
table below (bold).
TABLE 27-2: 6-LEAD SOT-23 (OT)
PACKAGE TOP MARKING
R/W-0/0 R/W-0/0 R/W-0/0 U-0 U-0 U-0 R/W-0/0 R/W-0/0
NxPWS<2:0>
— — — NxCKS<1:0>
bit 7 bit 0
Legend:
R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’
u = Bit is unchanged x = Bit is unknown -n/n = Value at POR and BOR/Value at all other Resets
‘1’ = Bit is set ‘0’ = Bit is cleared
bit 1-0 NxCKS<1:0>: NCOx Clock Source Select bits
11 = LC1OUT
10 = HFINTOSC
01 = FOSC
00 = NCO1CLK pin
Part Number Marking
PIC10F322(T)-I/OT LA, LJ
PIC10F322(T)-E/OT LB, LK
PIC10F320(T)-I/OT LC
PIC10F320(T)-E/OT LD
PIC10LF322(T)-I/OT LE
PIC10LF322(T)-E/OT LF
PIC10LF320(T)-I/OT LG
PIC10LF320(T)-E/OT LH