Datasheet

PIC10F200/202/204/206
DS41239D-page 70 © 2007 Microchip Technology Inc.
TABLE 12-3: CALIBRATED INTERNAL RC FREQUENCIES – PIC10F200/202/204/206
FIGURE 12-3: RESET, WATCHDOG TIMER AND DEVICE RESET TIMER TIMING –
PIC10F200/202/204/206
AC CHARACTERISTICS
Standard Operating Conditions (unless otherwise specified)
Operating Temperature -40°C ≤ T
A ≤ +85°C (industrial),
-40°C ≤ T
A ≤ +125°C (extended)
Operating Voltage V
DD range is described in
Section 12.1 “DC Characteristics”.
Param
No.
Sym Characteristic
Freq
Tolerance
Min Typ† Max Units Conditions
F10 F
OSC Internal Calibrated
INTOSC
Frequency
(1,2)
± 1% 3.96 4.00 4.04 MHz VDD=3.5V @ 25°C
± 2% 3.92 4.00 4.08 MHz 2.5V ≤ V
DD ≤ 5.5V
0°C ≤ T
A ≤ +85°C (industrial)
± 5% 3.80 4.00 4.20 MHz 2.0V ≤ VDD ≤ 5.5V
-40°C ≤ T
A ≤ +85°C (industrial)
-40°C ≤ T
A ≤ +125°C (extended)
* These parameters are characterized but not tested.
† Data in the Typical (“Typ”) column is at 5V, 25°C unless otherwise stated. These parameters are for design
guidance only and are not tested.
Note 1: To ensure these oscillator frequency tolerances, V
DD and VSS must be capacitively decoupled as close to
the device as possible. 0.1 μF and 0.01 μF values in parallel are recommended.
2: Under stable VDD conditions
VDD
MCLR
Internal
POR
DRT
Timeout
(2)
Internal
Reset
Watchdog
Timer
Reset
32
31
34
I/O pin
(1)
32
32
34
30
Note 1: I/O pins must be taken out of High-Impedance mode by enabling the output drivers in software.
2: Runs on POR only.