Datasheet
PIC10F200/202/204/206
DS41239D-page 66 © 2007 Microchip Technology Inc.
12.2 DC Characteristics: PIC10F200/202/204/206 (Extended)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise specified)
Operating Temperature -40×C £ T
A £ +125×C (extended)
Param
No.
Sym Characteristic Min Typ
(1)
Max Units Conditions
D001 V
DD Supply Voltage 2.0 5.5 V See Figure 12-1
D002 V
DR RAM Data Retention Voltage
(2)
1.5* — V Device in Sleep mode
D003 V
POR VDD Start Voltage
to ensure Power-on Reset
—Vss— V
D004 S
VDD VDD Rise Rate
to ensure Power-on Reset
0.05* — — V/ms
I
DD Supply Current
(3)
D010 —
—
175
0.63
275
1.1
μA
mA
VDD = 2.0V
V
DD = 5.0V
I
PD Power-down Current
(4)
D020 —
—
0.1
0.35
9
15
μA
μA
VDD = 2.0V
V
DD = 5.0V
I
WDT WDT Current
(5)
D022 —
—
1.0
7
18
22
μA
μA
VDD = 2.0V
V
DD = 5.0V
I
CMP Comparator Current
(5)
D023 —
—
12
42
27
85
μA
μA
VDD = 2.0V
V
DD = 5.0
VREF Internal Reference Current
(5), (6)
D024 — 85
175
120
200
μA
μA
VDD = 2.0V
V
DD = 5.0V
* These parameters are characterized but not tested.
Note 1: Data in the Typical (“Typ”) column is based on characterization results at 25°C. This data is for design guidance only
and is not tested.
2: This is the limit to which V
DD can be lowered in Sleep mode without losing RAM data.
3: The supply current is mainly a function of the operating voltage and frequency. Other factors such as bus loading, bus
rate, internal code execution pattern and temperature also have an impact on the current consumption.
a) The test conditions for all I
DD measurements in active operation mode are:
All I/O pins tri-stated, pulled to V
SS, T0CKI = VDD, MCLR = VDD; WDT enabled/disabled as specified.
b) For standby current measurements, the conditions are the same, except that the device is in Sleep mode.
4: Power-down current is measured with the part in Sleep mode, with all I/O pins in high-impedance state and tied to V
DD
or V
SS.
5: The peripheral current is the sum of the base I
DD or IPD and the additional current consumed when this peripheral is
enabled.
6: Measured with the Comparator enabled.