Datasheet
2004-2013 Microchip Technology Inc. DS40001239E-page 67
PIC10F200/202/204/206
12.3 DC Characteristics: PIC10F200/202/204/206 (Industrial, Extended)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise specified)
Operating temperature -40°C T
A +85°C (industrial)
-40°C T
A +125°C (extended)
Operating voltage V
DD range as described in DC specification
Param
No.
Sym Characteristic Min Typ† Max Units Conditions
V
IL Input Low Voltage
I/O ports:
D030 with TTL buffer Vss — 0.8 V For all 4.5 V
DD 5.5V
D030A Vss — 0.15 V
DD V Otherwise
D031 with Schmitt Trigger
buffer
Vss — 0.2 V
DD V
D032 MCLR
, T0CKI Vss — 0.2 VDD V
V
IH Input High Voltage
I/O ports: —
D040 with TTL buffer 2.0 — V
DD V4.5 VDD 5.5V
D040A 0.25 V
DD + 0.8 — VDD V Otherwise
D041 with Schmitt Trigger
buffer
0.8V
DD —VDD V For entire VDD range
D042 MCLR
, T0CKI 0.8VDD —VDD V
D070 I
PUR GPIO weak pull-up current
(3)
50 250 400 AVDD = 5V, VPIN = VSS
IIL Input Leakage Current
(1, 2)
D060 I/O ports — ±0.1 ± 1 AVss VPIN VDD, Pin at high-imped-
ance
D061 GP3/MCLR
(4)
—±0.7± 5AVss VPIN VDD
Output Low Voltage
D080 I/O ports — — 0.6 V I
OL = 8.5 mA, VDD = 4.5V, -40C to
+85C
D080A — — 0.6 V I
OL = 7.0 mA, VDD = 4.5V, -40C to
+125C
Output High Voltage
D090 I/O ports
(2)
VDD – 0.7 — — V IOH = -3.0 mA, VDD = 4.5V, -40C to
+85C
D090A V
DD – 0.7 — — V IOH = -2.5 mA, VDD = 4.5V, -40C to
+125C
Capacitive Loading Specs on Output Pins
D101 All I/O pins — — 50* pF
† Data in “Typ” column is at 5V, 25C unless otherwise stated. These parameters are for design guidance only and are not
tested.
* These parameters are for design guidance only and are not tested.
Note 1: The leakage current on the MCLR
pin is strongly dependent on the applied voltage level. The specified levels represent
normal operating conditions. Higher leakage current may be measured at different input voltages.
2: Negative current is defined as coming out of the pin.
3: This specification applies when GP3/MCLR
is configured as an input with pull-up disabled. The leakage current of the
MCLR
circuit is higher than the standard I/O logic.