Datasheet

 2004-2013 Microchip Technology Inc. DS40001239E-page 57
PIC10F200/202/204/206
RETLW Return with literal in W
Syntax: [ label ] RETLW k
Operands: 0  k  255
Operation: k  (W);
TOS  PC
Status Affected: None
Description: The W register is loaded with the
eight-bit literal ‘k’. The program
counter is loaded from the top of
the stack (the return address). This
is a two-cycle instruction.
RLF Rotate Left f through Carry
Syntax: [ label ] RLF f,d
Operands: 0  f  31
d  [0,1]
Operation: See description below
Status Affected: C
Description: The contents of register ‘f’ are
rotated one bit to the left through
the Carry flag. If ‘d’ is ‘0’, the result
is placed in the W register. If ‘d’ is
‘1’, the result is stored back in
register ‘f’.
RRF Rotate Right f through Carry
Syntax: [ label ] RRF f,d
Operands: 0  f  31
d  [0,1]
Operation: See description below
Status Affected: C
Description: The contents of register ‘f’ are
rotated one bit to the right through
the Carry flag. If ‘d’ is ‘0’, the result
is placed in the W register. If ‘d’ is
‘1’, the result is placed back in
register ‘f’.
C
register ‘f’
C
register ‘f’
SLEEP Enter SLEEP Mode
Syntax:
[ label ]
SLEEP
Operands: None
Operation: 00h  WDT;
0  WDT prescaler;
1  TO
;
0  PD
Status Affected: TO, PD, RBWUF
Description: Time-out Status bit (TO
) is set. The
Power-down Status bit (PD
) is
cleared.
RBWUF is unaffected.
The WDT and its prescaler are
cleared.
The processor is put into Sleep
mode with the oscillator stopped.
See Section 9.9 “Power-Down
Mode (Sleep)” for more details.
SUBWF Subtract W from f
Syntax:
[ label ] SUBWF f,d
Operands: 0 f 31
d  [0,1]
Operation: (f) – (W) dest)
Status Affected: C, DC, Z
Description: Subtract (2’s complement method)
the W register from register ‘f’. If ‘d’
is ‘0’, the result is stored in the W
register. If ‘d’ is ‘1’, the result is
stored back in register ‘f’.
SWAPF Swap Nibbles in f
Syntax: [ label ] SWAPF f,d
Operands: 0  f  31
d  [0,1]
Operation: (f<3:0>)  (dest<7:4>);
(f<7:4>)  (dest<3:0>)
Status Affected: None
Description: The upper and lower nibbles of
register ‘f’ are exchanged. If ‘d’ is
‘0’, the result is placed in W
register. If ‘d’ is ‘1’, the result is
placed in register ‘f’.