User Manual
Table Of Contents
- Features:
- Operational:
- RF/Analog Features:
- MAC/Baseband Features:
- Pin Diagram:
- Table of Contents
- Most Current Data Sheet
- Errata
- Customer Notification System
- 1.0 Device Overview
- 2.0 Circuit Description
- 3.0 Regulatory Approval
- 4.0 Electrical Characteristics
- Appendix A: Revision History
- The Microchip Web Site
- Customer Change Notification Service
- Customer Support
- Reader Response
- Product Identification System
© 2011 Microchip Technology Inc. Preliminary DS00000A-page 21
MRF24J40MC
3.3 Europe
The MRF24J40MC module conforms to the emission
standards summarized in Table 3-3. The module tests
can be applied toward product Declaration of
Conformity (DoC).
The European Standards do not provide a modular
approval similar to the USA (FCC) and Canada (IC).
However, the completed compliance testing can be
used as part of the customer’s application for product
compliance approvals. The module test report data can
be used as part of the customer’s product test plan and
can significantly lower customer’s compliance burden.
Depending on the end application, additional testing
may be required. The integrator is responsible for testing
the end product for any additional compliance
requirements that become necessary with this module
installed (for example, digital device emission, PC
peripheral requirements and so on) in the specific
country where end device is marketed)
Note: To maintain conformance tested ETSI
standards, the module shall not be
modified and settings in Section 1.3,
Operation must be observed.
TABLE 3-3: EMISSIONS STANDARDS TESTED
Specification
Test Method
Emission Standards
EN 300 328 V1.7.1 (2006-10) 4.3.1 Maximum Transmit Power 5.7.2
EN 300 328 V1.7.1 (2006-10) 4.3.2 Maximum EIRP Spectral Density 5.7.3
EN 300 328 V1.7.1 (2006-10) 4.3.3 Frequency Range 5.7.4
EN 300 328 V1.7.1 (2006-10) 4.3.6 Transmitter Spurious Emissions 5.7.5
EN 300 328 V1.7.1 (2006-10) 4.3.7 Receiver Spurious Emissions 5.7.6