User manual

MCP6V01 Input Offset Demo Board User’s Guide

3.3 CONNECTING A CHIP SELECT PIN TO GROUND

The DUT can be changed to the MCP6V03 or MCP6V08 op amps with chip select. If

desired, their Chip Select pin (pin 8) can be forced to ground. This is done as follows

(see Figure 3-2):

1. Solder one end of a wire to the DUT’s pin 8. Pin 8 is next to the U1 reference

designator on the PCB (not next to the DUT label)

2. Solder the other end of the wire the closest ground via on the PCB. The striped

green arrow to the right in the figure shows the location. The solid green curve

represents the wire.

FIGURE 3-2: Location and Orientation of DUT.

DUT’s Pin 8 Ground Via