User manual

MCP6V01 INPUT OFFSET

DEMO BOARD USER’S GUIDE

Chapter 3. Possible Modifications

3.1 INTRODUCTION

This chapter shows simple modifications to the MCP6V01 Input Offset Demo Board:

• Changing the DUT

• Connecting a Chip Select Pin to Ground

3.2 CHANGING THE DUT

Change the DUT (see Figure 3-1) to the MCP6V06 Op Amp as follows:

1. Remove U1 from the PCB, using a de-soldering tool.

2. Solder a MCP6V06 op amp in its place. Use a MCP6V06 in a SOIC-8 package.

Pin 1 is next to the U1 reference designator on the PCB (not next to the DUT

label)

FIGURE 3-1: Location and Orientation of DUT.

Label

DUT’s Pin 1

Reference Designator