Datasheet

MCP6566/6R/6U/7/9
DS22143D-page 4  2009-2013 Microchip Technology Inc.
Push-Pull Output
Pull-up Voltage V
PULL_UP
1.6 — 5.5 V
High-Level Output Voltage V
OH
——V
PULL_UP
V (see Figure 1-1) (Notes 3, 4)
High-Level Output Current Leakage I
OH_leak
—— 1 µANote 4
Low-Level Output Voltage V
OL
——0.6 VI
OUT
= 3mA/8mA @ V
DD
= 1.8V/5.5V
Short Circuit Current (Notes 3) I
SC
— ±30 — mA Not to exceed Absolute Max. Rating
Output Pin Capacitance C
OUT
—8 —pF
DC CHARACTERISTICS (CONTINUED)
Electrical Characteristics: Unless otherwise indicated: V
DD
= +1.8V to +5.5V, V
SS
= GND, T
A
= +25°C, V
IN
+ = V
DD
/2, V
IN
- = V
SS
,
and R
Pull-Up
= 20 k to V
PU
= V
DD
(see Figure 1-1).
Parameters Symbol Min Typ Max Units Conditions
Note 1: The input offset voltage is the center of the input-referred trip points. The input hysteresis is the difference between the
input-referred trip points.
2: V
HYST
at different temperatures is estimated using V
HYST
(T
A
) = V
HYST @ +25°C
+ (T
A
- 25°C) TC
1
+ (T
A
- 25°C)
2
TC
2
.
3: Limit the output current to Absolute Maximum Rating of 50 mA.
4: The pull-up voltage for the open drain output V
PULL_UP
can be as high as the absolute maximum rating of 10.5V. In this
case, I
OH_leak
can be higher than 1 µA (see Figure 2-30).
AC CHARACTERISTICS
Electrical Characteristics: Unless otherwise indicated,: Unless otherwise indicated,: V
DD
= +1.8V to +5.5V, V
SS
= GND,
T
A
= +25°C, V
IN+
= V
DD
/2, V
IN-
= V
SS
, R
Pull-Up
= 20 k to V
PU
= V
DD
, and C
L
= 25 pf (see Figure 1-1).
Parameters Symbol Min Typ Max Units Conditions
Propagation Delay
High-to-Low,100 mV Overdrive t
PHL
—5680 nsV
CM
= V
DD
/2, V
DD
= 1.8V
—3480 nsV
CM
= V
DD
/2, V
DD
= 5.5V
Output
Fall Time t
F
—20— ns
Maximum Toggle Frequency f
TG
—4—MHzV
DD
= 5.5V
—2—MHzV
DD
= 1.8V
Input Voltage Noise E
NI
—350—µV
P-P
10 Hz to 10 MHz (Note 1)
Note 1: ENI is based on SPICE simulation.
2: Rise time t
R
and t
PLH
depend on the load (R
L
and C
L
). These specification are valid for the specified load only.
TEMPERATURE SPECIFICATIONS
Electrical Characteristics: Unless otherwise indicated: V
DD
= +1.8V to +5.5V and V
SS
= GND.
Parameters Symbol Min Typ Max Units Conditions
Temperature Ranges
Specified Temperature Range T
A
-40 — +125 °C
Operating Temperature Range T
A
-40 — +125 °C
Storage Temperature Range T
A
-65 — +150 °C
Thermal Package Resistances
Thermal Resistance, SC70-5 
JA
— 331 — °C/W
Thermal Resistance, SOT-23-5 
JA
—220.7— °C/W
Thermal Resistance, 8L-MSOP 
JA
—211—°C/W
Thermal Resistance, 8L-SOIC 
JA
—149.5— °C/W
Thermal Resistance, 14L-SOIC 
JA
—95.3— °C/W
Thermal Resistance, 14L-TSSOP 
JA
— 100 — °C/W