User manual

MCP6031 PHOTODIODE PICtail™

PLUS DEMO BOARD USER’S GUIDE

Preface

INTRODUCTION

This chapter contains general information that will be useful to know before using the

MCP6031 Photodiode PICtail™ Plus Demo Board . Items discussed in this chapter

include:

• Document Layout

• Conventions Used in this Guide

• Recommended Reading

• The Microchip Web Site

• Customer Support

• Document Revision History

DOCUMENT LAYOUT

This document describes how to use the MCP6031 Photodiode PICtail™ Plus Demo

Board as a development tool to emulate and debug firmware on a target board. The

manual layout is as follows:

• Chapter 1. “Product Overview” – Provides the important information about the

MCP6031 Photodiode PICtail™ Plus Demo Board .

• Chapter 2. “Installation and Operation” – Covers the installation and operation

of the MCP6031 Photodiode PICtail™ Plus Demo Board .

• Appendix A. “Schematic and Layouts” – Shows the schematic and board

layouts for the MCP6031 Photodiode PICtail™ Plus Demo Board .

• Appendix B. “Bill of Materials (BOM)” – Lists the parts used to build the

MCP6031 Photodiode PICtail™ Plus Demo Board .

NOTICE TO CUSTOMERS

All documentation becomes dated, and this manual is no exception. Microchip tools and

documentation are constantly evolving to meet customer needs, so some actual dialogs

and/or tool descriptions may differ from those in this document. Please refer to our web site

(www.microchip.com) to obtain the latest documentation available.

Documents are identified with a “DS” number. This number is located on the bottom of each

page, in front of the page number. The numbering convention for the DS number is

“DSXXXXXA”, where “XXXXX” is the document number and “A” is the revision level of the

document.

For the most up-to-date information on development tools, see the MPLAB

IDE on-line help.

Select the Help menu, and then Topics to open a list of available on-line help files.