User manual

MCP4725 SOT-23-6 Evaluation Board User’s Guide

7. Select the Voltage Source option for the MCP4725 SOT-23-6 Evaluation

Board and click

the Next > button.

Case 1: When you use V

from the PICkit Serial Analyzer:

If you choose PICkit Serial will power my device option, and the 5 Volt option

as shown below, the MCP4725 SOT-23-6 Evaluation Board is powered by the 5

VDC from the PICkit Serial Analyzer through the J1 connector. In this case, make

sure that the JP2 jumper on the MCP4725 SOT-23-6 Evaluation Board is con-

nected.

You can also click on the Other option and move the slide bar for other than

5volts.

Case 2: When you use your own V

If you want to provide your own V

voltage through the V

terminal on the

MCP4725 SOT-23-6 Evaluation Board, then do not select the PICkit Serial will

power my device option. In this case, you have to remove the JP2 jumper on

the board and provide the V

at the V

terminal.