User manual

MCP46XXEV Evaluation Board User’s Guide
DS51929A-page 16 © 2010 Microchip Technology Inc.
TABLE 2-1: INSTALLED PASSIVE COMPONENTS
(2)
Component Description Comment
R11U, R17U 0Ω SMT 805 Pull-up resistor
R14U, R15U 10 kΩ SMT 805 Pull-up resistor
R7D, R13D 0Ω SMT 805 Pull-down resistor
(1)
U3 MCP4661-103E/ST R
AB(TYP)
= 10 kΩ
P9, P12 Test Point - through hole connector
(Orange)
J1 1x6 Male Header, 100 mil spacing 90°
angle.
PICkit
Serial / ICSP header
Blue Wire:
J1 SDI/SDA via to P6 via
J1 SCK/SCL via to P5 via
See
Figure 2-2
Note 1: Whichever pin is the device’s V
DD
pin, that corresponding RXD footprint can be used for the device’s
bypass capacitor. So if Pin 8 is the device’s V
DD
pin, then install the bypass capacitor in the R8D footprint.
2: All passive components use the surface mount 805 footprint.