Datasheet

MCP453X/455X/463X/465X
DS22096B-page 6  2008-2013 Microchip Technology Inc.
Maximum current
through Terminal (A, W
or B)
Note 6
I
T
— — 2.5 mA Terminal A I
AW
,
W = Full-Scale (FS)
— — 2.5 mA Terminal B I
BW
,
W = Zero Scale (ZS)
— — 2.5 mA Terminal W I
AW
or I
BW
,
W = FS or ZS
——1.38mA
Terminal A
and
Terminal B
I
AB
, V
B
= 0V,
V
A
= 5.5V,
R
AB(MIN)
= 4000
— — 0.688 mA I
AB
, V
B
= 0V,
V
A
= 5.5V,
R
AB(MIN)
= 8000
— — 0.138 mA I
AB
, V
B
= 0V,
V
A
= 5.5V,
R
AB(MIN)
= 40000
— — 0.069 mA I
AB
, V
B
= 0V,
V
A
= 5.5V,
R
AB(MIN)
= 80000
Leakage current into A,
W or B
I
WL
—100—nAMCP4XX1 PxA = PxW = PxB = V
SS
—100—nAMCP4XX2 PxB = PxW = V
SS
— 100 — nA Terminals Disconnected
(R1HW = R0HW = 0)
AC/DC CHARACTERISTICS (CONTINUED)
DC Characteristics
Standard Operating Conditions (unless otherwise specified)
Operating Temperature –40°C  T
A
 +125°C (extended)
All parameters apply across the specified operating ranges unless noted.
V
DD
= +2.7V to 5.5V, 5 k, 10 k, 50 k, 100 k devices.
Typical specifications represent values for V
DD
= 5.5V, T
A
= +25°C.
Parameters Sym Min Typ Max Units Conditions
Note 1: Resistance is defined as the resistance between terminal A to terminal B.
2: INL and DNL are measured at V
W
with V
A
= V
DD
and V
B
= V
SS
.
3: MCP4XX1 only.
4: MCP4XX2 only, includes V
WZSE
and V
WFSE
.
5: Resistor terminals A, W and B’s polarity with respect to each other is not restricted.
6: This specification by design.
7: Non-linearity is affected by wiper resistance (R
W
), which changes significantly overvoltage and
temperature.
8: The MCP4XX1 is externally connected to match the configurations of the MCP45X2 and MCP46X2, and
then tested.
9: POR/BOR is not rate dependent.
10: Supply current is independent of current through the resistor network.
11: When HVC/A0 = V
IHH
, the I
DD
current is less due to current into the HVC/A0 pin. See I
PU
specification.