User manual

MCP401X/2X Evaluation Board User’s Guide

These programmers use the PICkit™ 1 Baseline Flash Programmer software. This GUI

should be configured as shown in Figure C-2. Selecting Device Power causes the

BFMP to power the attached board all the time (not just during programming). This

allows the MCP402X Digital Potentiometer Evaluation Board to be easily demonstrated

without needing to carry a power supply (although a DMM is still required).

FIGURE C-2: PICkit™ 1 Baseline Flash Programmer - Configuration #2.

Ensure Device Power IS checked and

Select PIC10F206

2.5 kHz Osc is NOT checked.

Note: When programming the MCP402X Digital Potentiometer Evaluation Board,

under

“Board Controls”

, DO NOT check Device Power. This ensures that

the PIC10F206 is only powered during the programming cycle.