User manual

Quick Start Instructions
© 2009 Microchip Technology Inc. DS51787A-page 15
5. Change the parameter value.
I2CSTART
I2CWRTBYT
02
D0
98
I2CSTOP
Script Detail
------> This means there are two bytes to send
------> 1st Write Byte: Address byte with W
/R bit = 1101-0000
------> 2nd Write Byte: Configuration byte = 1001-1000
*
*
*
Note: All 6 parameters above must be listed in the same order as shown here.
The parameters above with * are not modifiable. Address bits
(A2, A1, A0) = (0,0,0) for this evaluation board. See the MCP3425 Data
Sheet for more information on address bit selection.