Datasheet

Quick Start Instructions

7. Select the V

voltage of the MCP3424 Evaluation Board and click the Next

button.

Case 1: When you use V

from the PICkit Serial Analyzer:

If you choose PICkit Serial will power your device and 5 Volts as shown below,

the MCP3424 Evaluation Board is powered by the 5V DC from the PICkit Serial

Analyzer through the JP1 jumper. In this case, make sure that the JP1 jumper on

the MCP3424 Evaluation Board is connected.

Case 2: When you use your own V

You can also provide your own V

voltage by applying a V

voltage at VD1

test point. In this case, make sure that the JP1 jumper is disconnected.