User manual

MCP3422 Evaluation Board for PICkit™ Serial User’s Guide

1.3.3 Reading the Conversion Data using the PICkit Serial Analyzer

You can read back the conversion data by following the next steps.

1.3.3.1 CREATING A SCRIPT FILE TO READ THE CONVERSION DATA

1. Click on ReadAddrA8 in “Example I2C Scripts” column.

This will result in filling in the spaces under the “Script Detail”column. Now you

can modify the parameter boxes (delete or insert) in the “Script Detail” column

with options. The list of options will appear if you click with the right mouse button

on the parameter box. You can delete the parameter box or add a new one.

2. Make sure the Script Detail parameters are listed in order as follows:

FIGURE 1-13: Script File Sample to Read Conversion Data.

I2CSTART

I2CWRTBYT

I2CRDBYTNLB

I2CSTOP

Script Detail

------> This means there is one byte for address

------> Address byte with W/R bit = 1101-0001

------> 5 bytes to read

Note: All 7 parameters above must be listed in order. The parameters above with

* are not modifiable.

Requesting

Address Byte

5 Bytes