User manual

Quick Start Instructions

FIGURE 1-10: Modifying Parameters in Script Builder Window.

4. Change the parameter value.

1. To change value:

• Click this box and type a

new number.

2. To delete or insert box:

• Choose the box and

right-click the mouse button for

options available

3. Make sure the listed parameters

in “Script Detail” should be in

exact order as shown here.

I2CSTART *

I2CWRTBYT *

I2CSTOP *

Script Detail

------> This means there are two bytes to send

------> 1st Write Byte: Address byte with W/R bit = 1101-0000

------> 2nd Write Byte (Configuration Byte): 1001-1100

Note: All 6 parameters above must be listed in the same order as shown here.

The parameters above with * are not modifiable.