Datasheet
Table Of Contents
- Features
- CMOS Technology
- Packages
- Package Types
- Block Diagram
- 1.0 Device OvervieW
- 1.1 Pin Descriptions
- 1.2 Power-on Reset (POR)
- 1.3 Power-up Timer (PWRT)
- 1.4 Clock Generator
- 1.5 I2C Bus Interface/ Protocol Handler
- 1.6 Address Decoder
- 1.7 Register Block
- 1.8 Serializer/Deserializer
- 1.9 Interrupt Logic
- 2.0 Electrical Characteristics
- 2.1 DC Characteristics
- TABLE 2-1: DC Characteristics
- FIGURE 2-1: respOnse time
- TABLE 2-2: response time
- FIGURE 2-2: TEST POINT Clock Timing
- TABLE 2-3: TEST POINT Clock Timing
- TABLE 2-4: Power-up Timer Requirements
- FIGURE 2-3: I2C Bus Start/Stop Bits Timing
- FIGURE 2-4: I2C Bus Data Timing
- TABLE 2-5: I2C Bus Data Requirements
- FIGURE 2-5: GP0 and GP1 POrt Timings
- 2.1 DC Characteristics
- 3.0 Package InFormation
- Appendix A: Revision History
- Product Identification System
- Worldwide Sales and Service
MCP23016
DS20090C-page 8 © 2007 Microchip Technology Inc.
1.7.3 INPUT POLARITY REGISTERS
These registers allow the user to configure the polarity
of the input port data (GP0 and GP1). If a bit in this reg-
ister is set, the corresponding input port (GPn) data bit
polarity will be inverted.
• IPOL0 (controls the polarity of GP0)
• IPOL1 (controls the polarity of GP1)
REGISTER 1-5: IPOL0 - INPUT POLARITY PORT REGISTER 0
REGISTER 1-6: IPOL1 - INPUT POLARITY PORT REGISTER 1
R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0
IGP0.7 IGP0.6 IGP0.5 IGP0.4 IGP0.3 IGP0.2 IGP0.1 IGP0.0
bit 7 bit 0
bit 7-0
IGP0.0:IGP0.7: Controls the polarity inversion for the input pins
1 = Corresponding GP0 bit is inverted
0 = Corresponding GP0 bit is not inverted
Legend:
R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’
- n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown
R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0
IGP1.7 IGP1.6 IGP1.6 IGP1.4 IGP1.3 IGP1.2 IGP1.1 IGP1.0
bit 7 bit 0
bit 7-0
IGP1.0:IGP1.7: Controls the polarity inversion for the input pins
1 = Corresponding GP1 bit is inverted
0 = Corresponding GP1 bit is not inverted
Legend:
R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’
- n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown