Datasheet

MCP19111
DS22331A-page 88  2013 Microchip Technology Inc.
PIE1 87h -000 --00 -000 --00 -uuu --uu
PIE2 88h 0-00 --00 0-00 --00 u-uu --uu
APFCON 89h ---- ---0 ---- ---0 ---- ---u
VINLVL 90h 0-xx xxxx 0-uu uuuu u-uu uuuu
OCCON 91h 0xxx xxxx 0uuu uuuu uuuu uuuu
CSGSCON 93h -xxx xxxx -uuu uuuu -uuu uuuu
CSDGCON 95h 0--- xxxx 0--- uuuu u--- uuuu
VZCCON 97h xxxx xxxx uuuu uuuu uuuu uuuu
CMPZCON 98h xxxx xxxx uuuu uuuu uuuu uuuu
OUVCON 99h xxxx xxxx uuuu uuuu uuuu uuuu
OOVCON 9Ah xxxx xxxx uuuu uuuu uuuu uuuu
DEADCON 9Bh xxxx xxxx uuuu uuuu uuuu uuuu
SLPCRCON 9Ch xxxx xxxx uuuu uuuu uuuu uuuu
SLVGNCON 9Dh ---x xxxx ---u uuuu ---u uuuu
RELEFF 9Eh 0000 0000 0000 0000 uuuu uuuu
WPUGPA 105h --1- 1111 --u- uuuu --u- uuuu
WPUGPB 106h 1111 -11- uuuu -uu- uuuu -uu-
PE1 107h 0000 1100 0000 1100 uuuu uuuu
BUFFCON 108h 000- 0000 000- 0000 uuu- uuuu
ABECON 109h 0000 0000 0000 0000 uuuu uuuu
SSPADD 110h 0000 0000 0000 0000 uuuu uuuu
SSPBUF 111h xxxx xxxx uuuu uuuu uuuu uuuu
SSPCON1 112h 0000 0000 0000 0000 uuuu uuuu
SSPCON2 113h
0000 0000
0000 0000
uuuu uuuu
SSPCON3 114h
0000 0000
0000 0000
uuuu uuuu
SSPMSK 115h
1111 1111 1111 1111 uuuu uuuu
SSPSTAT 116h
SSPADD2 117h 0000 0000 0000 0000 uuuu uuuu
SSPMSK2 118h 1111 1111 1111 1111 uuuu uuuu
IOCA 185h 0000 0000 0000 0000 uuuu uuuu
IOCB 186h 0000 -000 0000 -000 uuuu -uuu
ANSELA 187h ---- 1111 ---- 1111 ---- uuuu
ANSELB 188h --11 -11- --11 -11- --uu -uu-
PMCON1 190h -0-- -000 -0-- -000 -u-- -uuu
PMCON2 191h ---- ---- ---- ---- ---- ----
PMADRL 192h 0000 0000 0000 0000 uuuu uuuu
PMADRH 193h ---- -000 ---- -000 ---- -uuu
PMDATL 194h 0000 0000 0000 0000 uuuu uuuu
TABLE 14-3: INITIALIZATION CONDITION FOR REGISTERS (CONTINUED)
Register Address
Power-on
Reset
MCLR
Reset
WDT Reset
Wake-up from Sleep through
Interrupt
Wake-up from Sleep through
WDT Time-out (Continued)
Legend: u = unchanged, x = unknown, – = unimplemented bit, reads as ‘0’, q = value depends on condition.
Note 1: If V
DD
goes too low, Power-on Reset will be activated and registers will be affected differently.
2: One or more bits in INTCON and/or PIRx will be affected (to cause wake-up).
3: When the wake-up is due to an interrupt and the GIE bit is set, the PC is loaded with the interrupt vector (0004h).
4: See Table 14-5 for Reset value for specific condition.