Datasheet

 2012 Microchip Technology Inc. DS52086A-page 1
dsPIC33EP256MC506
The dsPIC33EP256MC506 External Op Amp Motor
Control PIM is designed to demonstrate the
capabilities of the dsPIC33EP256MC506 motor
control device, using external on-board op amps
with development boards, such as the dsPICDEM™
MCLV-2 Development Board (DM330021-2) and
the dsPICDEM MCHV-2 Development Board
(DM330023-2), which support 100-pin PIM
interfaces.
The dsPIC33EP256MC506 is a high-performance, 16-bit
Digital Signal Controller (DSC) in a 64-pin TQFP
package.
To operate this PIM with the dsPICDEM MCLV-2 and
dsPICDEM MCHV-2 Development Boards, please insert
the External Op Amp Configuration Board into the
header, J4, (for the dsPICDEM MCHV-2 Development
Board) or header, J14 (for the dsPICDEM MCLV-2
Development Board).
Figure 1 shows the connection location for the
dsPICDEM MCHV-2 Development Board.
FIGURE 1: EXTERNAL OP AMP
CONFIGURATION BOARD
Hardware Compatibility
Table 1 provides information on the hardware versions
of the motor control boards that are compatible with this
PIM. Refer to the user’s guide for the specific motor
control board for hardware version identification
information.
TABLE 1: HARDWARE COMPATIBILITY
Development Board Part Number Compatible Hardware Version(s)
dsPICDEM™ MCHV Development Board DM330023 Not compatible
dsPICDEM™ MCLV Development Board DM330021 Not compatible
dsPICDEM™ MCSM Development Board DM330022 Not compatible
dsPICDEM™ MCHV-2 Development Board DM330023-2 All revisions
dsPICDEM™ MCLV-2 Development Board DM330021-2 All revisions
Warning: Do not connect non-isolated oscilloscope probes to the test points on the dsPIC33EP256MC506 External
Op Amp Motor Control PIM while using the PIM with the dsPICDEM™ MCHV-2 Development Board. Use
a high-voltage differential probe, rated in excess of 600 V
RMS (Common mode). Failure to heed this warning
could result in hardware damage.
dsPIC33EP256MC506 Plug-In Module (PIM)
Information Sheet for External Op Amp Configuration