Datasheet
dsPIC33FJ16(GP/MC)101/102 AND dsPIC33FJ32(GP/MC)101/102/104
DS70000652F-page 222 2011-2014 Microchip Technology Inc.
19.5 ADC Control Registers
REGISTER 19-1: AD1CON1: ADC1 CONTROL REGISTER 1
R/W-0 U-0 R/W-0 U-0 U-0 U-0 R/W-0 R/W-0
ADON —ADSIDL— — —FORM1FORM0
bit 15 bit 8
R/W-0 R/W-0 R/W-0 U-0 R/W-0 R/W-0 R/W-0, HC, HS R/C-0, HC, HS
SSRC2 SSRC1 SSRC0
— SIMSAM ASAM SAMP DONE
bit 7 bit 0
Legend: C = Clearable bit HS = Hardware Settable bit HC = Hardware Clearable bit
R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’
-n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown
bit 15 ADON: ADC1 Operating Mode bit
1 = ADC1 module is operating
0 = ADC1 is off
bit 14 Unimplemented: Read as ‘0’
bit 13 ADSIDL: ADC1 Stop in Idle Mode bit
1 = Discontinues module operation when device enters Idle mode
0 = Continues module operation in Idle mode
bit 12-10 Unimplemented: Read as ‘0’
bit 9-8 FORM<1:0>: Data Output Format bits
11 = Signed fractional (D
OUT = sddd dddd dd00 0000, where s = .NOT.d<9>)
10 = Fractional (D
OUT = dddd dddd dd00 0000)
01 = Signed integer (D
OUT = ssss sssd dddd dddd, where s = .NOT.d<9>)
00 = Integer (D
OUT = 0000 00dd dddd dddd)
bit 7-5 SSRC<2:0>: Sample Clock Source Select bits
111 = Internal counter ends sampling and starts conversion (auto-convert)
110 =CTMU
101 = Reserved
100 = Reserved
011 = Motor control PWM interval ends sampling and starts conversion
(1)
010 = GP Timer3 compare ends sampling and starts conversion
001 = Active transition on INT0 pin ends sampling and starts conversion
000 = Clearing SAMP bit ends sampling and starts conversion
bit 4 Unimplemented: Read as ‘0’
bit 3 SIMSAM: Simultaneous Sample Select bit (applicable only when CHPS<1:0> = 01 or 1x)
1 = Samples CH0, CH1, CH2, CH3 simultaneously (when CHPS<1:0> = 1x) or samples CH0 and CH1
simultaneously (when CHPS<1:0> = 01)
0 = Samples multiple channels individually in sequence
bit 2 ASAM: ADC1 Sample Auto-Start bit
1 = Sampling begins immediately after last conversion; SAMP bit is auto-set
0 = Sampling begins when the SAMP bit is set
Note 1: This feature is available in dsPIC33FJ(16/32)MC10X devices only.