Datasheet

dsPIC33FJ16(GP/MC)101/102 AND dsPIC33FJ32(GP/MC)101/102/104
DS70000652F-page 178  2011-2014 Microchip Technology Inc.
14.1 Output Compare Modes
Configure the Output Compare modes by setting the
appropriate Output Compare Mode bits (OCM<2:0>) in
the Output Compare x Control (OCxCON<2:0>)
register. Table 14-1 lists the different bit settings for the
Output Compare modes. Figure 14-2 illustrates the
output compare operation for various modes. The user
application must disable the associated timer when
writing to the Output Compare Control registers to
avoid malfunctions.
TABLE 14-1: OUTPUT COMPARE x MODES
FIGURE 14-2: OUTPUT COMPARE x OPERATION
Note: See “Output Compare” in the “dsPIC33/
PIC24 Family Reference Manual”
(DS70209) for OCxR and OCxRS register
restrictions.
OCM<2:0> Mode OCx Pin Initial State OCx Interrupt Generation
000 Module Disabled Controlled by GPIO register —
001 Active-Low One-Shot 0 OCx Rising Edge
010 Active-High One-Shot 1 OCx Falling Edge
011 Toggle Current output is maintained OCx Rising and Falling Edge
100 Delayed One-Shot 0 OCx Falling Edge
101 Continuous Pulse 0 OCx Falling Edge
110 PWM without Fault Protection 0, if OCxR is zero
1, if OCxR is non-zero
No Interrupt
111 PWM with Fault Protection 0, if OCxR is zero
1, if OCxR is non-zero
OCFA Falling Edge for OC1 to OC4
OCxRS
TMRy
OCxR
Timer is Reset on
Period Match
Continuous Pulse Mode
(OCM<2:0> = 101)
PWM Mode
(OCM<2:0> = 110 or 111 )
Active-Low One-Shot
(OCM<2:0> = 001)
Active-High One-Shot
(OCM<2:0> = 010)
Toggle Mode
(OCM<2:0> = 011)
Delayed One-Shot
(OCM<2:0> = 100)
Output Compare
Mode Enabled