Datasheet

dsPIC33FJ32GS406/606/608/610 and dsPIC33FJ64GS406/606/608/610
DS70000591F-page 418  2009-2014 Microchip Technology Inc.
28.1 DC Characteristics
TABLE 28-1: OPERATING MIPS vs. VOLTAGE
Characteristic
V
DD Range
(in Volts)
Temp Range
(in °C)
Max MIPS
dsPIC33FJ32GS406/606/608/610 and
dsPIC33FJ64GS406/606/608/610
— 3.0-3.6V
(1)
-40°C to +85°C 50
Note 1: Overall functional device operation at V
BORMIN < VDD < VDDMIN is tested but not characterized. All device
analog modules, such as the ADC, etc., will function but with degraded performance below V
DDMIN. See
Parameter BO10 in Table 27-11 for the BOR values.
TABLE 28-2: DC CHARACTERISTICS: OPERATING CURRENT (IDD)
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V (unless otherwise stated)
Operating temperature -40°C  T
A  +85°C for Industrial
Parameter
No.
Typical Max Units Conditions
Operating Current (I
DD)
(1)
MDC29d 85 100 mA -40°C
3.3V 50 MIPSMDC29a 85 100 mA +25°C
MDC29b 85 100 mA +85°C
Note 1: I
DD is primarily a function of the operating voltage and frequency. Other factors, such as I/O pin loading
and switching rate, oscillator type, internal code execution pattern and temperature, also have an impact
on the current consumption. The test conditions for all IDD measurements are as follows:
• Oscillator is configured in EC mode with PLL, OSC1 is driven with external square wave from
rail-to-rail (EC clock overshoot/undershoot < 250 mV required)
• CLKO is configured as an I/O input pin in the Configuration Word
• All I/O pins are configured as inputs and pulled to VSS
•MCLR = VDD, WDT and FSCM are disabled
• CPU, SRAM, program memory and data memory are operational
• No peripheral modules are operating; however, every peripheral is being clocked (all PMDx bits are
zeroed)
• CPU executing while(1) statement
• JTAG is disabled