Datasheet

 2008-2014 Microchip Technology Inc. DS70000318G-page 291
dsPIC33FJ06GS101/X02 and dsPIC33FJ16GSX02/X04
DC27d 111 140 mA -40°C
3.3V
40 MIPS
See Note 2, except PWM is
operating at 1/4 speed
(PTCON2 = 0x0002)
DC27a 108 130 mA +25°C
DC27b 105 130 mA +85°C
DC27c 103 130 mA +125°C
DC28d 102 130 mA -40°C
3.3V
40 MIPS
See Note 2, except PWM is
operating at 1/8 speed
(PTCON2 = 0x0003)
DC28a 100 120 mA +25°C
DC28b 100 120 mA +85°C
DC28c 100 120 mA +125°C
TABLE 24-5: DC CHARACTERISTICS: OPERATING CURRENT (IDD) (CONTINUED)
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C  T
A  +85°C for Industrial
-40°C  T
A  +125°C for Extended
Parameter
No.
Typical
(1)
Max Units Conditions
Operating Current (I
DD)
(2)
Note 1: Data in “Typical” column is at 3.3V, +25°C unless otherwise stated.
2: I
DD is primarily a function of the operating voltage and frequency. Other factors, such as I/O pin loading
and switching rate, oscillator type, internal code execution pattern and temperature, also have an impact
on the current consumption. The test conditions for all IDD measurements are as follows:
• Oscillator is configured in EC mode with PLL, OSC1 is driven with external square wave from
rail-to-rail (EC clock overshoot/undershoot < 250 mV required)
• CLKO is configured as an I/O input pin in the Configuration Word
• All I/O pins are configured as inputs and pulled to VSS
•MCLR = VDD, WDT and FSCM are disabled
• CPU, SRAM, program memory and data memory are operational
• No peripheral modules are operating; however, every peripheral is being clocked (all PMDx bits are
zeroed)
• CPU executing while(1) statement
• JTAG disabled
3: These parameters are characterized but not tested in manufacturing.