Datasheet

 2008-2014 Microchip Technology Inc. DS70000318G-page 247
dsPIC33FJ06GS101/X02 and dsPIC33FJ16GSX02/X04
REGISTER 19-1: ADCON: ANALOG-TO-DIGITAL CONTROL REGISTER
R/W-0 U-0 R/W-0 R/W-0 U-0 R/W-0 U-0 R/W-0
ADON
— ADSIDL SLOWCLK
(1)
—GSWTRG—FORM
(1)
bit 15 bit 8
R/W-0 R/W-0 R/W-0 R/W-0 U-0 R/W-0 R/W-1 R/W-1
EIE
(1)
ORDER
(1,2)
SEQSAMP
(1,2)
ASYNCSAMP
(1)
— ADCS2
(1)
ADCS1
(1)
ADCS0
(1)
bit 7 bit 0
Legend:
R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’
-n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown
bit 15 ADON: Analog-to-Digital Operating Mode bit
1 = Analog-to-Digital Converter (ADC) module is operating
0 = ADC Converter is off
bit 14 Unimplemented: Read as ‘0’
bit 13 ADSIDL: ADC Stop in Idle Mode bit
1 = Discontinues module operation when device enters Idle mode
0 = Continues module operation in Idle mode
bit 12 SLOWCLK: Enable The Slow Clock Divider bit
(1)
1 = ADC is clocked by the auxiliary PLL (ACLK)
0 = ADC is clock by the primary PLL (F
VCO)
bit 11 Unimplemented: Read as ‘0’
bit 10 GSWTRG: Global Software Trigger bit
When this bit is set by the user, it will trigger conversions if selected by the TRGSRC<4:0> bits in the
ADCPCx registers. This bit must be cleared by the user prior to initiating another global trigger (i.e., this
bit is not auto-clearing).
bit 9 Unimplemented: Read as ‘0’
bit 8 FORM: Data Output Format bit
(1)
1 = Fractional (DOUT = dddd dddd dd00 0000)
0 = Integer (D
OUT = 0000 00dd dddd dddd)
bit 7 EIE: Early Interrupt Enable bit
(1)
1 = Interrupt is generated after first conversion is completed
0 = Interrupt is generated after second conversion is completed
bit 6 ORDER: Conversion Order bit
(1,2)
1 = Odd numbered analog input is converted first, followed by conversion of even numbered input
0 = Even numbered analog input is converted first, followed by conversion of odd numbered input
bit 5 SEQSAMP: Sequential Sample Enable bit
(1,2)
1 = Shared Sample-and-Hold (S&H) circuit is sampled at the start of the second conversion if
ORDER = 0. If ORDER = 1, then the shared S&H is sampled at the start of the first conversion.
0 = Shared S&H is sampled at the same time the dedicated S&H is sampled if the shared S&H is not
currently busy with an existing conversion process. If the shared S&H is busy at the time the
dedicated S&H is sampled, then the shared S&H will sample at the start of the new conversion cycle.
Note 1: These control bits can only be changed while ADC is disabled (ADON = 0).
2: These bits are only available on devices with one SAR.