Datasheet

 2008-2014 Microchip Technology Inc. DS70000318G-page 213

dsPIC33FJ06GS101/X02 and dsPIC33FJ16GSX02/X04

bit 3-2 CLDAT<1:0>: State for PWMxH and PWMxL Pins if CLMODE is Enabled bits

(2)

FCLCONx<IFLTMOD> = 0: Normal Fault mode:

If current-limit is active, then CLDAT<1> provides the state for PWMxH

If current-limit is active, then CLDAT<0> provides the state for PWMxL

FCLCONx<IFLTMOD> =

1: Independent Fault mode:

CLDAT<1:0> bits are ignored.

bit 1 SWAP<1:0>: Swap PWMxH and PWMxL pins

1 = PWMxH output signal is connected to the PWMxL pin and the PWMxL signal is connected to the

PWMxH pins

0 = PWMxH and PWMxL pins are mapped to their respective pins

bit 0 OSYNC: Output Override Synchronization bit

1 = Output overrides via the OVRDAT<1:0> bits are synchronized to the PWM time base

0 = Output overrides via the OVDDAT<1:0> bits occur on the next CPU clock boundary

Note 1: These bits should be changed only when PTEN = 0. Changing the clock selection during operation will

yield unpredictable results.

2: The state represents the active/inactive state of the PWM module depending on the POLH and POLL bit

settings.