User manual

!
www.rovingnetworks.com Version 1.1 9/20/2012 7
RN-131/171-PICTAIL-UM
Figure 4. Data Mode Operation Jumper Selection
!
2. Use the MPLAB X IDE and the programmer to load the SampleTelnetApp.hex demo application into the
PIC18F87J11.
3. Press the MCLR reset button on the Explorer 18 board and observe the output transaction on the terminal
emulator console. A normal sequence is similar to that shown in Figure 5, i.e., the device is associated with the
designated access point, and the yellow LED on the RN-131-PICTAIL/RN-171-PICTAIL is illuminated.