Datasheet

Hi-Speed USB 2.0 to 10/100/1000 Ethernet Controller
Datasheet
Revision 1.0 (11-01-10) 32 SMSC LAN7500/LAN7500i
DATASHEET
Figure 4.2 flowcharts PME operation while in Internal PHY mode. The following conditions hold:
EEPROM Configuration:
 GPIO PME Enable = 1 (enabled)
 GPIO PME Configuration = 0 (PME signaled via level on GPIO5 pin)
 GPIO PME Length = 0 (NA)
 GPIO PME Polarity = 1 (high level signals event)
 GPIO PME Buffer Type = 1 (Push-Pull)
 GPIO PME WOL Select = 0 (Magic Packet wakeup)
 Power Method = 1 (self powered)
 MAC address for Magic Packet
PME signaling configuration:
 GPIO5 signals PME
 GPIO6 is PME_MODE_SEL