Datasheet
Table Of Contents
- 1.0 Introduction
- 2.0 Pin Description and Configuration
- 3.0 Functional Description
- 3.1 10BASE-T/100BASE-TX Transceiver
- 3.2 RMII Interface
- 3.3 Back-to-Back Mode – 100 Mbps Copper Repeater
- 3.4 MII Management (MIIM) Interface
- 3.5 Interrupt (INTRP)
- 3.6 HP Auto MDI/MDI-X
- 3.7 Loopback Mode
- 3.8 LinkMD® Cable Diagnostic
- 3.9 NAND Tree Support
- 3.10 Power Management
- 3.11 Reference Circuit for Power and Ground Connections
- 3.12 Typical Current/Power Consumption
- 4.0 Register Descriptions
- 5.0 Operational Characteristics
- 6.0 Electrical Characteristics
- 7.0 Timing Diagrams
- 8.0 Reset Circuit
- 9.0 Reference Circuits — LED Strap-In Pins
- 10.0 Reference Clock - Connection and Selection
- 11.0 Magnetic - Connection and Selection
- 12.0 Package Outline
KSZ8081RNA/RND
DS00002199A-page 34 2016 Microchip Technology Inc.
Note 4-1 RW = Read/Write; RO = Read Only; SC = Self-Cleared; LH = Latch High; LL = Latch Low.
1F.2 Remote
Loopback
1 = Remote (analog) loopback is enabled
0 = Normal mode
RW 0
1F.1 Reserved Reserved RW 0
1F.0 Disable Data
Scrambling
1 = Disable scrambler
0 = Enable scrambler
RW 0
TABLE 4-2: REGISTER DESCRIPTIONS (CONTINUED)
Address Name Description
Mode
Note 4-1
Default