User manual

dsPICDEM™ MCSM Development Board User’s Guide
DS70610A-page 24 © 2009 Microchip Technology Inc.
3.3 BOARD CONNECTORS
Figure 3-3 shows the various user interface components available on the dsPICDEM
MCSM Development Board. Table 3-4 describes the hardware connection between the
PICkit™ 3, MPLAB
®
ICD 3 or MPLAB REAL ICE™ In-Circuit Emulator, the power
supply, and the dsPICDEM MCSM Development Board connectors.
FIGURE 3-3: dsPICDEM MCSM DEVELOPMENT BOARD USER INTERFACE COMPONENTS
TABLE 3-4: dsPICDEM MCSM DEVELOPMENT BOARD USER INTERFACE
COMPONENTS
J8
D3-D10
S1
POT1
J2
J1
J4
J3
BP2
BP1
J7
J5
J6
RESET
U2
Designator Description
BP1-BP2 Auxiliary power supply connector
D3-D10 PWM LEDs
S1 Push button switch 1
RESET Device Reset switch
POT1 Potentiometer
U2 Plug-in Module (PIM) adaptor
J1 RJ11, 6-pin connector for programming a dsPIC
®
DSC device
J2 ICSP connector for programming a dsPIC DSC device
J3 ICSP™ programmer interface connector for programming the PIC18LF2450
USB-to-UART bridge
J4 USB interface port
J5 24V power supply select jumper
J6 24V Input power supply connector
J7 Auxiliary power supply select jumper
J8 Motor power connector