Manualshelf

User manual

ManualsBrandsMICROCHIP TECHNOLOGY ManualsDev KitsPCB design board
21222324252627282930
Operation
2013 Microchip Technology Inc. DS52116A-page 21
2.5 COMMUNICATION CONNECTIONS
2.5.1 Standard Communication Target Connections
2.5.1.1 USING SINGLE IN-LINE CONNECTOR
Use the 6-pin in-line connector between the PICkit 3 In-Circuit Debugger/Programmer
and the target board connector. See Figure 2-1. Also see Table 2-2 and
Section A.6 “Standard Communication Hardware”.
2.5.1.2 USING AN ADAPTER
Use the AC164110 adapter between the PICkit 3 In-Circuit Debugger/Programmer and
the target device with the modular interface (six conductor) cable. The pin numbering
for the connector is shown from the bottom of the target PC board in Figure 2-3.
FIGURE 2-3: STANDARD RJ-11 CONNECTION AT TARGET
TABLE 2-2: TARGET CONNECTOR PINOUT
Connector Pin Microcontroller Pin
1MCLR/VPP
2VDD
3 Ground
4 PDG (ICSPDAT)
5 PGC (ICSPCLK)
6 PGM (LVP)
Note: Cable connections at the debugger and target are mirror images of each
other, i.e., pin 1 on one end of the cable is connected to pin 6 on the other
end of the cable. See Section A.6.2.3 “Modular Cable Specification”.