User manual

PICkit™ Serial Analyzer User’s Guide
DS51647A-page 50 © 2007 Microchip Technology Inc.
6.4 SELECTING COMMUNICATIONS MODE
The USART Asynchronous Communications mode is selected from the Configuration
Wizard or menu bar.
Configuration Wizard – Select PICkit Serial Analyzer > Run Configuration Wizard
from the menu bar
Menu Bar – Select PICkit Serial Analyzer > Select Communications Mode > USART
Asynchronous
6.5 CONFIGURING USART ASYNCHRONOUS COMMUNICATIONS MODE
Once the communications mode has been selected, it is configured from the
Configuration Wizard or menu bar.
Configuration Wizard – Select PICkit Serial Analyzer > Run Configuration Wizard
from the menu bar
Menu Bar – S
elect PICkit Serial Analyzer > Configure Communications Mode
The Configure Mode window will open. Depending on the view selected, the Basic View
(Figure 6-1) displays a minimum choice of configurations commands. In the Advanced
View (Figure 6-2) displays an extended choice of configuration commands.
Save the configuration by clicking on the Save Changes button.
FIGURE 6-1: USART ASYNCHRONOUS CONFIGURE COMMUNICATIONS
MODE – BASIC VIEW
OPTIONS
• Enable Event Markers
– Enable event markers
• Enable Time Markers
– Enable ‘time’ stamp to accompany all event markers
VOLTAGE
• PICkit Serial will power my device
– Select the check box if the PICkit Serial will
power the target device. The target can be powered at 5 V
DC or a user selectable
variable voltage.
CAUTION
Even though the voltage can be set as low as 0 VDC, it is up to the user to verify the
required operating voltage of the target device.