User manual

PICkit™ Serial Analyzer User’s Guide

FIGURE 3-4: CONFIGURATION WIZARD – PAGE 2 OF 4

The I

C bus requires pull-up resistors. The PICkit Serial Analyzer has the ability to

enable internal 2.2 kΩ pull-up resistors. If the target device does not have pull-up resis-

tors installed, then enable pull-ups by selecting the Yes radio button as shown in

Figure 3-5. If the target device has the pull-up resistors installed, you can disable the

internal pull-ups by selecting the No radio button.

FIGURE 3-5: CONFIGURATION WIZARD – PAGE 3 OF 4

The PICkit Serial Analyzer can power the target device from 0 to 5 V

DC at a combined

total current limit of 100 mA (PICkit Serial Analyzer plus target device). The Configura-

tion Wizard Page 4 of 4, as shown in Figure 3-6, allows you to choose between

powering the target device and selecting the specific target voltage.

CAUTION

Even though the voltage can be set as low as 0 VDC, it is up to the user to verify the

required operating voltage of the target device.

CAUTION

The USB port current limit is set to 100 mA. If the target plus PICkit Serial Analyzer

exceeds this current limit, the USB port will turn off. The target may be powered

externally if more power is required.