User manual

PICkit™ Serial Analyzer User’s Guide

2.5 CONNECTING THE PICkit™ SERIAL ANALYZER TO THE 28-PIN DEMO

BOARD

Connect the PICkit Serial Analyzer to P3 on the 28-Pin Demo Board as shown in Figure

2-1. The PICkit Serial Analyzer will supply power to the 28-Pin Demo Board and

perform a power on routine:

• LEDs will flash in sequence DS1, DS2, DS3, DS4, DS3, DS2, and DS1 twice

• All LEDs will turn off

• All LEDs will turn on

• All LEDs will turn off

• LEDs will display in hexadecimal: A, D, C

• LEDs will display the top 4 bits of the ADC value read from potentiometer RP1

FIGURE 2-1: CONNECTING PICkit™ SERIAL TO THE 28-PIN DEMO

BOARD

2.6 STARTING THE PICkit™ SERIAL ANALYZER PROGRAM

You can start the program by:

• Clicking on the desktop icon, or

• Navigating to Start>All Programs>Microchip>PICkit Serial Analyzer

After a few moments, the program will start and display the main window as shown in

Figure 2-2.

If this is the first time you are running the program, the Configuration Wizard will auto-

matically run. Click on the Next button and accept the default settings for I

C Master

mode. For more information about using the I

C Master mode, see Chapter 4. “I

C™

Master Communications.”