Datasheet

Debug Header Connections
 2006-2015 Microchip Technology Inc. DS50001292W-page 89
B.4 6-PIN SIL CONNECTOR
Debug headers with 6-pin SIL connectors are compatible with the tools listed below.
PICkit 3 Programmer/Debug Express
The 6-pin socket of the PICkit 3 may be directly connected to the 6 header pins. Be
sure to line up pin 1 on the PICkit with pin 1 on the header.
FIGURE B-4: 6-PIN SIL CONNECTION TO A PICKIT
MPLAB ICD 3 In-Circuit Debugger
The 6-pin modular cable attached to the MPLAB ICD 3 may be connected to the 6
header pins through the Modular-to-SIL Adapter.
MPLAB REAL ICE In-Circuit Emulator
The 6-pin modular cable attached to the Standard Driver Board may be connected to
the 6 header pins through the Modular-to-SIL Adapter. No SPI trace is available with
this connection because of the loss of the DAT and CLK pins.
The 8-pin socket of the High Speed Driver Board or optional Isolation Unit may be con-
nected directly to the 6 header pins. Be sure to line up pin 1 on the board with pin 1 on
the header.
FIGURE B-5: 6-PIN SIL CONNECTION TO AN EMULATOR
Note: No SPI trace is possible in this case because of the loss of DAT and CLK
pins. However, if the device supports SPI, two additional header pins can
be attached to add this functionality.
PICkit 3
P
I
C
k
i
t
TOP
Header
Connector
TOP
1
1
1
J1
DAT
CLK
J3 J2
TOP
Header
Connector
MPLAB REAL ICE in-circuit emulator
High-Speed Receiver Board or
optional Isolation Unit
TOP
1
Optional SPI trace
2-Pin right angle header
can be installed here.
(Digi-Key P/N A32702-02-ND)